NCP51105ASNT1G

onsemi
863-NCP51105ASNT1G
NCP51105ASNT1G

Fabricante:

Descripción:
Controladores de puertas ORDERABLE PART FOR NCP51105A

Ciclo de vida:
Nuevo en Mouser
Modelo ECAD:
Descargue Library Loader gratis para convertir este archivo para su herramienta ECAD. Conozca más sobre el modelo ECAD.

En existencias: 2,942

Existencias:
2,942 Se puede enviar inmediatamente
Plazo de entrega de fábrica:
17 Semanas Tiempo estimado de producción de fábrica para cantidades superiores a las que se muestran.
Mínimo: 1   Múltiples: 1
Precio unitario:
$-.--
Precio ext.:
$-.--
Est. Tarifa:

Precio (USD)

Cantidad Precio unitario
Precio ext.
$0.94 $0.94
$0.673 $6.73
$0.607 $15.18
$0.534 $53.40
$0.499 $124.75
$0.478 $239.00
$0.461 $461.00
Envase tipo carrete completo (pedir en múltiplos de 3000)
$0.439 $1,317.00
$0.42 $2,520.00

Atributo del producto Valor de atributo Seleccionar atributo
onsemi
Categoría de producto: Controladores de puertas
RoHS:  
Gate Drivers
Single
SMD/SMT
TSOP-6
1 Driver
1 Output
12.7 V
25 V
5 ns
5 ns
- 40 C
+ 125 C
NCP51105A
Reel
Cut Tape
Marca: onsemi
Voltaje de entrada - Máx.: 25 V
Voltaje de entrada - Mín.: 12.7 V
Tipo lógico: CMOS, TTL
Corriente de suministro operativa: 700 uA
Dp - Disipación de potencia : 500 mW
Tipo de producto: Gate Drivers
Cantidad de empaque de fábrica: 3000
Subcategoría: PMIC - Power Management ICs
Productos encontrados:
Para mostrar productos similares, seleccione al menos una casilla de verificación
Seleccione al menos una de las casillas de verificación anteriores para mostrar productos similares en esta categoría.
Atributos seleccionados: 0

USHTS:
8542390090
ECCN:
EAR99

NCP51105 Single 2.6A Low-Side Gate Driver

onsemi NCP51105 Single 2.6A Low-Side Gate Driver is a high-current driver designed to drive power MOSFETs and IGBTs. The logic input is compatible with CMOS and TTL output. The NCP51105 features an OCP pin that provides over-current protection with negative voltage detected across a switching current sensing resistor and an EN pin that can report faults status to an external controller such as an MCU. The EN pin must be pulled up to a higher voltage than the threshold for normal operation and pulled down to disable output in all fault conditions. Internal VDD circuitry provides an under-voltage lockout function by holding the output low until the supply voltage is recovered into the operating range, and the fault recovery time can be programmable by a time-constant set of resistance and capacitance connected to the EN pin.